1.5"(50.5mm) Tri-clamp Brew Heater 304 Stainless Steel Electric Boilers

Heating Elements1.5"(50.5mm) Tri-clamp Brew Heater 304 Stainless Steel Ten 220V Electric Boilers for Heating With Clamp and Adpter 1pcSpecifications:Product Name: Flange Disc Heating TubeTube Length: 200mm/215mm/260mm/320mm/360mmVoltage: 110V/220V/380VPower: 1.5KW/2.5KW/3.5KW/4.5KW/5.5KWTube Diameter: 8mmThread Diameter: 32mmFlange Disc: 50.5mm (1.5inch Tri-clamp)Tube Material: 304 stainless steelThread Material: 304 stainless steelPackage Contents: 1pc heating element with black cover,clamp and adpterPay attention: Power Allowance-10%~+5%01/Introduction to Heating Tube:This heating tube is used as a heating element inside water tanks, boilers, and water towers for brewing and fermentation equipment. No matter what you choose, you can replace it with the appropriate specifications.02/How to measure the size of heating tubes :Voltage: 220V or 380V, Power: How many KWFlange specifications: 51 flange=outer diameter 51mm, 64 flange=outer diameter 64mm, 77.5 flange=outer diameter 77.5mm, 91 flange=outer diameter 91mmTube length: The length can vary slightly, as long as it can be installed into the device03/Instructions: 1. Before installation, use a multimeter to test if the heating tube is powered on. If the measurement is correct, then proceed with installation. If the measurement is not powered on, please contact customer service.2. The heating area of the heating tube must be completely submerged underwater before the power can be turned on, and dehydration and dry burning are strictly prohibited. (Dehydration and dry burning refer to heating elements that are partially or completely exposed to the water surface and electrified in the air. As heat cannot be transferred out through water, it is completely absorbed by the metal tube, which can cause the metal tube body to turn black and bulge, and even burn, break, or melt.)3. If the heating equipment is equipped with an automatic water filling device, the ball valve needs to be recalibrated after each replacement of the heating tube to ensure that the liquid level is far above the position of the heating tube before it can be used.To dear all,1.Heaters are industrial products, not vase. some may have flaws, such as weld, such as stainless steel trace and polish trace,that's normal.2.Because the heating wire inside the heater tube is made of OCr25A15 which is Magnetic, it is normal that the element can be adsorbed by magnet.3.Under the condition of insulation, the international standard for the heater power accept allowance -10% to 5%.If you are care about these, please think twice before make order. Thank you for your attention.Application:The electric heating tube can not only be used as a heater for closed oil tanks, oil drums and hydraulic oil devices, but also as water tanks, boiler heaters, tank heaters, mold temperature machine heaters, etc., and are widely used in the heating of tanks-tanks-equipment in electronics, plastics, chemical industry and environmental engineering.

• Heating Elements
• 1.5"(50.5mm) Tri-clamp Brew Heater 304 Stainless Steel Electric Boilers